AGC-4
FAQ's for customers
Please follow the step-by-step instructions in the attached help guide.
Mon, 22 Aug, 2022 at 8:43 AM
Yes it is. Please follow below setup procedure: Paralleling connection and set up: 1. DEIF Controller setup : Menu 6390 in DEIF AGC-4 has the following o...
Mon, 22 Aug, 2022 at 8:43 AM
Please follow the step-by-step instructions in the attached help guide.
Mon, 22 Aug, 2022 at 8:45 AM
Yes, below is the wiring Diagram for the reference.
Mon, 22 Aug, 2022 at 8:44 AM
After a USW update, you can have problems connecting to our AGC-4, AGC-4 Mk II or AGC-150 using USB. You can see the emulated COM port, but when connecting...
Wed, 2 Feb, 2022 at 11:39 AM
The compatibility Check popup is opened by pressing the button. Then a popup like below is shown: In this popup the device type, the firmware ve...
Mon, 18 Sep, 2023 at 3:39 PM
Redundancy Some of the devices can be configured for redundancy. In a redundant setup two devices can control e.g. the same genset and breaker so if one fa...
Mon, 22 Aug, 2022 at 1:02 PM
It’s because the “primary” genset mode is Power Management, because of option G5. Then you are also able to run “another” genset mode, etc. “Island mode” th...
Mon, 22 Aug, 2022 at 1:04 PM
Check what Genset mode (CH - 6070) selected in all controllers, set it as Power Management. Cross verify the Load dependent Start / Stop selected unit, ty...
Mon, 22 Aug, 2022 at 1:08 PM
Power management functions: ● Load-dependent start/stop ● Priority selection ● Manual ● Running hours ● Fuel optimisation ● Ground relay control ● ATS cont...
Mon, 22 Aug, 2022 at 1:10 PM