Support

Cross verify the application configuration and set addresses (Int. Comm. ID Ch-7531) for all units in the system. This requires Laptop/PC for verifying the...

This information is related with CAN communication used for power management functions in DEIF’s multi-line units (option G4 and G5). CAN bus communic...

The values on DEIF’s product are often 16-bit, and when you're using Profibus you read 8-bit values. The lowest address is the MSB (Most Significant Byt...

Make sure the port number used in Utility Software is the same as converter is using. Check in Device Manager :     Further make sure converter is setu...

Make sure the port number used in Utility Software is the same as converter is using. Check in Device Manager : Further make sure converter is ...

Address #1 concerns "CosPhi regulator setpoint", which must be given a value between 60 and 100 - also if the regulator is not being used. Sometim...

To set up the communication with the device, open the Settings popup by pressing the following button in the menu bar: The Settings popup is a general...

The PC utility software (USW) and the service cable is needed to connect PPM-3 with PC. The USW is the software that is installed on the PC, notebook or de...

Please find below step wise guidelines, on how to change the IP address.   1. Connect the LAN cable between Laptop and controller Ethernet port.   2. Pre...

Our recommendation is no longer than 6 m cable. However, we have seen 10 m working without any problems. Also connecting 2 * 6 m standard cables together ha...