Support

FAQ 2

• Auslesen der Log Dateien DEIF AGC-3, AGC-4, GPC-3, PPU-3, ML-2
• Neue Firmware aufspielen DEIF AGC, GPC, GPU, PPU, ML2

General 1

• What are default DEIF Controller Passwords for different level access ?

General 27

• How to upgrade options on following DEIF products ML2, AGC 150, AGC 200
• What is the Procedure for sending faulty equipment to DEIF Denmark ?
• What are default DEIF Controller Passwords for different level access ?
• Rücksetzen des kWh Timers DEIF (GPC & GPU-3, AGC-3, AGC-4, AGC-4 MKII, PPU-3, PPM-3)
• How to change IP on windows PC

See all 27 articles

AGC-4 11

• How to wire & do the parameter setup for J1939 engine communication ?
• Is it possible to achieve analogue load share between Cummins PCC 3.3 and AGC-4?
• Is it possible to achieve analogue load sharing between Cummins PCC 3100 and AGC-3/4 ?
• AGC-4 and AGC 150 driver issue fix
• How to wire & parameterize analogue load share ?

See all 11 articles

AGC 200 5

• How to configure & setup Beckhoff external I/O modules ?
• How to wire and set up synchronization + load share between PCC 3100 and AGC 242 ?
• Optionen freischalten/ Upgrade option for DEIF units
• How to get the AGC 200 Application Software?
• I’m facing Counters Reset issue - what is the rate of saving counters data in AGC-200

PPM-3 1

• What is the maximum number of units in a PPM-3 system ?

Utility Software 3 5

• How do I create a batch file using the USW?
• How to change operation modes from Utility software?
• How can I use Trend function in USW to monitor live current readings ?
• How to configure/map Modbus & Profibus addresses used in my SCADA system ?
• How to flash controller when stuck in boot mode?

Communication 10

• CAN alarm/issues: Any DG missing / Any Mains missing/Any BTB missing
• What is the requirements in regards to CAN communication ?
• How to calculate a decimal number 16-bit value from two 8-bit values ?
• How to connect PC to device using a USB to serial RS232 converter ?
• How to connect PC to device using a USB to serial RS485 converter ?

See all 10 articles

WSDI-2 1

• How to setup true wind measurement using WSDI-2 interfacing with NMEA converter ?

WSS 1

• Safety distance to radar

RT-2 1

• Rudder angle transmitter is giving erratic signal - how to troubleshoot ?

XDI 1

• Updating Library in XDI

MIC-2 1

• Where can I find the MIC-2 Profi-Bus GSD-file?

Setup 6

• How to setup a FX30, and connect it to insight.
• How to setup a EX703 TCP/IP, and get it connected to insight?
• How to add new controller
• How use the User menu / add user / add role / add team
• Antenna dimensions

See all 6 articles

Debug 3

• FX30: Randomly loosing connection but it reconnects after some time:
• FX30: Data session is disconnected
• How to open the log on Ex703.

Ticket flow chart 0

Shared files 0

Deleted files 0